Interface Instance
Use the (config-if) instance to configure the interfaces – Ethernet, VLAN and tunnel
associated with the switch.
To switch to this mode, use the command:
For RFSwitch7000:
RFSwitch(config)#interface [<interface-name>|ge <1-4>|me1|
sa <1-4>|vlan <1-4094>]
RFSwitch(config-if)#
For RFSwitch6000:
RFSwitch(config)#interface [<interface-name>|ge <1-8>|me1|
up1|vlan <1-4094>]
RFSwitch(config-if)#
For RFSwitch4000:
RFSwitch(config)#interface [<interface-name>|ge <1-5>|me1|
up1|vlan <1-4094>|sa <1-6>|wwan]
RFSwitch(config-if)#
12.1 Interface Config Commands
Table 12.1 summarizes the (config-if) commands:
Table 12.1 Interface Config Command Summary
Command Description Ref.
clrscr Clears the display screen page 12-4
To Next Page
Loading...
