Motorola RFS Series

Motorola RF Switch CLI Reference Guide
16-14
16.1.9 service
 Standard ACL Config Commands
Invokes service commands to troubleshoot or debug (config-if) instance
configurations
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
service show cli
Parameters
Example
RFSwitch(config-std-nacl)#service show cli
Standard ACL Config mode:
+-clrscr [clrscr]
+-deny
+-A.B.C.D/M [(deny|permit|mark (8021p <0-7> | tos <0-
255>))(A.B.C.D/M | host A.B.C.D | any)(log|)(rule-precedence
<1-5000> |)]
+-log [(deny|permit|mark (8021p <0-7> | tos <0-
255>))(A.B.C.D/M | host A.B.C.D | any)(log|)(rule-precedence
<1-5000> |)]
+-rule-precedence
+-<1-5000> [(deny|permit|mark (8021p <0-7> | tos <0-
255>))(A.B.C.D/M | host A.B.C.D | any)(log|)(rule-precedence
<1-5000> |)]
+-rule-precedence
+-<1-5000> [(deny|permit|mark (8021p <0-7> | tos <0-
255>))(A.B.C.D/M | host A.B.C.D | any)(log|)(rule-precedence
<1-5000> |)]
+-any [(deny|permit|mark (8021p <0-7> | tos <0-
255>))(A.B.C.D/M | host A.B.C.D | any)(log|)(rule-precedence
<1-5000> |)]
cli Displays the CLI tree of the current mode