Motorola RF Switch CLI Reference Guide
20-68
20.1.41 radio
Wireless Configuration Commands
Sets radio related parameters
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
radio [<1-4096>|<radio-list>|add|all-11a|all-11an|all-11b|
all-11bg|all-11bgn|antenna-mode|configure-8021X|
default-11a|default-11an|default-11b|default-11bg|
default-11bgn|dns-name]
radio [<1-4096>|<radio-list>|all-11a|all-11an|all-llb|
all-11bg|all-11bgn|default-11a|default-11an|default-11b|
default-11bg||default-11bgn] [acs-exception-list|
admission-control|
adoption-policy|adoption-pref-id|ampdu|amsdu|antenna-mode|
base-bridge|beacon-interval|bridge-fwd-delay <4-30>|
bridge-hello <1-10>|bridge-max-ageout <4-3600>|
bridge-msg-age <6-40>|bridge-priority <0-65535>|bss|
channel-power|client-bridge|copy-config-from|description|
detector|dtim-period|dot11k|dynamic-chain-sel|enforce-
spec-mgmt|
enhanced-beacon-table|enhanced-probe-table|
group-id [<0-48>|<0-255>|<0-64>]|location-led|
location-message|mac|max-mobile-units|mesh-associations|
moto-simple-voice enable|mu-power <0-20>|nas-id|
nas-port-id|on-channel-scan|radio-number|
radar-test-mode|reset|reset-ap|
|rf-mode|rss|rts-threshold|run-acs|
self-heal-offset|short-gi|short-preamble|speed|timeout|
tunnel|wmm]
The radios group-id range differs from switch to switch.
• RFS7000 – Supports a range between 0-255
• RFS6000 – Supports a range between 0-64
• RFS4000 – Supports a range between 1-6
To Next Page
Loading...
