Motorola RFS Series

Motorola RF Switch CLI Reference Guide
17-10
17.1.6 mark
 MAC Extended ACL Config Commands
Specifies the packet to mark
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
mark [8021p|dscp|tos]
mark [8021p <vlan-priority-value>|dscp
<dscp-codepoint-value>|tos <tos-value>] [icmp|ip|tcp|udp]
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] icmp [<source-IP/
Mask>|any|host<IP>] [<dest-IP/mask>|any|host <IP>]
{<ICMP-type> {<ICMPcode>}}
{log} {rule-precedence <1-5000>]}
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] IP [<source-IP/
mask>|any|host <IP>][<dest-ip/mask>|any|host <IP>] {log}
{rule-precedence <1-5000>}
mark [8021p <vlan-priority-value>|dscp
<dscp-codepointvalue>|tos <tos-value>] [tcp|udp]
[source-IP/Mask>|any|host<IP>] {eq <source-port>|range
<starting-source-port> <ending-source-port>} [<dest-IP/
Mask|any|host <IP>] {eq <source-port>} {range
<starting-source-port> <ending-sourceport>}{log}
{rule-precedence <1-5000>}
NOTE: Use a decimal value representation of ethertypes to implement
permit/deny/mark designations for a packet. An Extended MAC ACL
provides the hexadecimal values for each listed ethertype. The switch
supports all ethertypes. Use the decimal equivalent of the ethertype
listed in the CLI or any other type of ethertype.