DHCP Server Instance
18-9
18.1.4 client-identifier
DHCP Config Commands
Assigns a name to the client-identifier
A client identifier is used to reserve an IP address for a DHCP client.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
client-identifier <identifier>
Parameters
Example
RFSwitch(config-dhcp)#client-identifier testid
RFSwitch(config-dhcp)#
client-identifier
<identifier>
Prepends a null character. Use \\0 at the
beginning (a single
\ in the input is ignored)
To Next Page
Loading...
