Motorola RFS Series User Manual

Global Configuration Commands
5-55
5.1.16 interface
 Global Configuration Commands
Configures a selected interface
This command is used to enter the interface configuration mode for the specified physical
Switch Virtual Interface (SVI) interface. If the VLANx (SVI) interface does not exist, it is
automatically created.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax (RFS7000)
interface [<interface-name>|ge <1-4>|me1|sa <1-4>|
vlan <1-4094>]
Syntax (RFS6000)
interface [<interface-name>|ge <1-8>|me1|up1|vlan <1-4094>]
Syntax(RFS4000)
interface [<interface-name>|ge <1-5>|me1|up1|sa <1-6>|vlan
<1-4094>|wwan]
SWITCH NOTE: The interfaces mentioned below are
supported in the following platforms:
• ge <index> – RFS7000 supports 4 GE’s and RFS6000 supports 8 GE’s
• sa <1-4> – Only supported with RFS7000
• me1 – Supported with RFS7000 and RFS6000
• up1 – Only supported with RFS6000
• wwan – Supported interface to RFS4000 and RFS6000
NOTE: The interface mode leads to the
config-if instance. For more
information, see Interface Instance on page 12-1. The prompt changes
from
RFSwitch(config) # to RFSwitch(config-if)

Motorola RFS Series Specifications

General

Brand	Motorola
Model	RFS Series
Category	Switch
Language	English