Spanning tree-mst Instance
Use the (config-mst) instance to configure the switch’s Multi Spanning Tree Protocol
(MSTP) configuration. To switch to this instance, use the command:
RFSwitch(config)#spanning-tree mst configuration
RFSwitch(config-mst)#
13.1 mst Config Commands
Table 13.1 summarizes the (config-mst) commands:
Table 13.1 MSTI configuration commands
Command Description Ref.
clrscr Clears the display screen page 13-3
end Ends the current mode and moves to the EXEC mode page 13-4
exit Ends the current mode and moves to the previous mode page 13-5
help Displays the system’s interactive help system page 13-6
instance Assigns a VLAN to the bridge instance page 13-7
name Sets a name for the MST region page 13-8
no Negates a command or sets defaults page 13-9
revision Configures the revision number of the MST bridge page 13-10
To Next Page
Loading...
Need help?
General
