Wireless Instance
20-23
20.1.8 ap-image
Wireless Configuration Commands
Defines the path to upload the new image over an AP
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
ap-image [ap100|ap300-ids-sensor|ap300-wisp|ap300-wispe|
ap4131|ap5131|ap650-wispe|ap7131|revert-ap4131] <file-path>
Parameters
Example
RFSwitch (config-wireless)#ap-image ap5131 flash:/
aap_10B.bin
RFSwitch (config-wireless)#
[ap100|
ap300-ids-sensor|
ap300-wisp|
ap300-wispe|
ap4131|ap5131|
ap650|ap7131|revert-
ap4131]
<file-path>
The interface to upload new AP image. The following APs
are supported:
• ap100 – AP image for AP100
• ap300-ids-sensor – IDS Sensor firmware for AP300
• ap300-wisp – WISP image for AP300
• ap300-wispe – WISPe image for AP300
• ap4131 – AP image for AP4131
• ap5131 – Adaptive AP image for AP5131
• ap650-wispe – AP image for ap650
• ap7131 – Adaptive AP image for AP7131
• revert-ap4131 – AP image for revert-AP4131
• <file-path> – Path of the new AP-Image
To Next Page
Loading...
