Motorola RF Switch CLI Reference Guide
20-22
Example
RFSwitch(config-wireless)#ap-detection enable
RFSwitch(config-wireless)#
RFSwitch(config-wireless)#ap-detection authorized add 150
any any
RFSwitch(config-wireless)#
RFSwitch(config-wireless)#ap-detection mu-assisted-scan
enable
RFSwitch(config-wireless)#
RFSwitch(config-wireless)#ap-detection mu-assisted-scan
refresh 520
RFSwitch(config-wireless)#
detect-wired-rouge
enable
Detection of the rogue APs which are also found on the
wired network
• enable – Starts detecting rogue APs on the wired
network
enable Allows access ports to look for APs
mu-assisted-scan
[enable|
refresh <refresh-period>]
Sets mobile unit assisted scanning configuration
• enable – Enables mobile unit assisted scanning
• refresh <refresh-period>> – Defines the period
<refresh-period> (300 – 86400) (in seconds) used by all
scan-capable mobile units are polled to scan for
neighboring access ports
ap-detection timeout
[authorized|ignored
unauthorized] <timeout>
Sets the amount of time (in seconds ) an AP remains in the
list after it is no longer seen
• authorized<timeout> – The timeout <timeout> in
seconds for authorized APs
• ignored <timeout> – The timeout <timeout> in seconds
for ignored APs
• unauthorized<timeout> – The timeout <timeout> in
seconds for unauthorized APs
To Next Page
Loading...
