Motorola RFS Series User Manual

Motorola RF Switch CLI Reference Guide
1-2
1.1 CLI Overview
The CLI is used for configuring, monitoring, and maintaining the switch managed network.
The user interface allows you to execute commands (on the supported RFS6000, RFS4000,
and RFS7000 models) using either a serial console or a remote access method.
This chapter describes the basic features of the CLI. Topics covered include an introduction
to command modes, navigation and editing features, help features, and command history.
1.1.1 Configuration for connecting to the CLI using a terminal
emulator
Use the following settings to configure your terminal emulator for connecting to the
switch’s CLI.
When a CLI session is established, to access the switch, do as follows (user input is in
bold)
login as: cli
User Access Verification
Username:
Use the following credentials when logging to the CLI for the first time.
When logging for the first time, you are prompted to change the password.
Bits Per Second 19200
Data Bits 8
Parity None
Stop Bit 1
Flow Control None
User Name admin
Password motorola

Motorola RFS Series Specifications

General

Brand	Motorola
Model	RFS Series
Category	Switch
Language	English