DHCP Server Instance
18-19
18.1.13 hardware-address
DHCP Config Commands
Reserves an IP address (manually) based on a DHCP client’s hardware address. Use the no
hardware-address command to remove this from the DHCP pool.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
hardware-address <MAC> {[ethernet|token-ring]}
Parameters
Usage Guidelines
Accepts only hexadecimal values
Example
RFSwitch(config-dhcp)#hardware-address 00:01:23:45:32:22
RFSwitch(config-dhcp)#
hardware-address
<MAC> {
ethernet|token-ring}
Sets the client's hardware address to <MAC>.
<MAC> can be in the format xx-xx-xx-xx-xx-xx
(dashed hexadecimal string) or
XX:XX:XX:XX:XX:XX (dotted hexadecimal string)
• <MAC> {ethernet|token-ring} – Defines a
dashed hexadecimal string
• <MAC> {ethernet|token-ring} – Sets a dotted
hexadecimal string
• ethernet – Ethernet
• token-ring – Token ring network
To Next Page
Loading...
