Motorola RF Switch CLI Reference Guide
20-60
20.1.35 multicast-throttle-watermark
Wireless Configuration Commands
Configures watermarks for supporting bursts of broadcast/multicast frames
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
multicast-throttle-watermarks low <0-100> high <0-100>
Parameters
Example
RFSwitch(config-wireless)#multicast-throttle-watermarks low
10 high 20
RFSwitch(config-wireless)#
low <0-100> Sets the low water-mark. If the percentage of free packets
in the system is lower than this threshold, the incoming
frame is dropped.
high <0-100> Sets the high water-mark. If the percentage of free packets
in the system is between the low water-mark and this
value, the packet is subjected to a random-early-drop. If
free packets are greater than this value, the packet is
processed.
To Next Page
Loading...
