Interface Instance
12-15
12.1.10 management
Interface Config Commands
Sets the selected interface as management interface. It can only be used on a VLANx
interface. The TFTP/FTP server providing the switch its config file at startup must be
accessible via this interface.
VLAN 1 is the default management interface for the switch.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
management
Parameters
None
Usage Guidelines
The management privilege can be set only on a L3 interface. Use this command along with
the
(config) management secure in the config mode. This ensure management access
is restricted to the management VLAN only
Refer to management on page 5-78 for
management configuration.
Example
RFSwitch(config)#interface vlan 1000
RFSwitch(config-if)#management
RFSwitch(config-if)#
To Next Page
Loading...
