Motorola RFS Series

Motorola RF Switch CLI Reference Guide
21-10
Usage Guidelines
Use no command to undo the configurations on the parameters mentioned in the table.
Refer to the parameters, within this chapter, for complete syntax.
Example
RFSwitch(config-rtls)#no aeroscout enable
RFSwitch
RFSwitch(config-rtls)#no ekahau enable
RFSwitch(config-rtls)#
RFSwitch(config-rtls)#no ekahau engine
RFSwitch(config-rtls)#
RFSwitch(config-rtls)#no service inventory 1 zone 1
RFSwitch(config-rtls)#
21.1.10 reference-tag
 RTLS Config Commands
Configures fixed RFID tag as reference tag and sets its coordinates within a specified
location
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
reference-tag rfid <tag-id> coordinates x <0-65535> y
<0-65535> {[z<0-65535>]}{orientation [0|90|180|270]}
{range <1-50>}
switch
[coordinates
|geo-
coordinates]
• Negates switch configuration parameters
• coordinates – Negates switch coordinates
configuration within the site
• geo-coordinates – Negates switch geo coordinates
configuration