Motorola RFS Series

Motorola RF Switch CLI Reference Guide
20-28
20.1.12 ap-udp-port
 Wireless Configuration Commands
Configures the UDP port for layer 3 adoption of APs
You also need to configure the DHCP server providing the APs the same parameter.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
ap-udp-port <port>
Parameters
Example
RFSwitch(config-wireless)#ap-udp-port 20
RFSwitch(config-wireless)#
<port> Sets the port number for layer 3 adoption of APs. <port> is
a value in the range 1-65535.