Motorola RFS Series

Radius Server Instance
19-17
RFSwitch(config-radsrv-group)#policy wlan 20 21 22 23
RFSwitch(config-radsrv-group)#
19.1.7.9 rad-user
 Radius Configuration Commands
Adds an existing RADIUS user to this group. If the RADIUS user is not available in the
Onboard RADIUS server’s database, create a new RADIUS user using the
rad-user
command from within the
(config-radsrv) mode.
For more information, see rad-user on page 19-37.
NOTE: It's strictly recommended to set hotspot simultaneous-users to 1 for corresponding WLAN
as guest user is being assigned access-duration.
Syntax
rad-user <name>
Parameters
Example
RFSwitch(config-radsrv)#rad-user user1 password user1
RFSwitch(config-radsrv)#group group1
RFSwitch(config-radsrv-group)#rad-user user1
RFSwitch(config-radsrv-group)#
19.1.7.10 rate-limit
 Radius Configuration Commands
Sets the rate limit for the RADIUS Server group
Syntax
rate-limit [wired-to-wireless|wireless-to-wired ]
<100-100000>
Parameters
<name> Existing RADIUS user name
wired-to-wireless
<100-100000>
Down link direction from network to wireless client
• <100-100000> – Rate in the range of <100-100000> kbps