RFID Instance
The (config-rtls-rfid) instance is used to configure RFID reader related
configuration parameters.
To navigate to this instance, use the commands
RFSwitch(config)#rtls
RFSwitch(config-rtls)#rfid
RFSwitch(config-rtls-rfid)#
23.1 RFID Config Commands
Table 23.1 summarizes config-rtls-rfid commands:
Table 23.1 RFID Config Commands
Command Description Ref.
activate Activates/enables RFID reader configuration page 23-3
clrscr Clears the display screen page 23-4
end Ends the current mode and moves to EXEC mode page 23-5
exit Ends current mode and moves to the previous
mode
page 23-6
help Description of the interactive help system page 23-7
no Negates a command or set its defaults page 23-8
reader RFID Readers configuration commands page 23-9
To Next Page
Loading...
