Introduction
This chapter describes the commands defined by the switch Command Line Interface (CLI).
Access the CLI (on the supported RFS6000, RFS4000, and RFS7000 models) by running a
terminal emulation program on a computer connected to the serial port on the front of the
switch, or by using a Telnet session via secure shell (SSH) to access the switch over the
network. The default CLI user designation is cli. The default username and password are
admin and superuser respectively.
To avoid confusion amongst RFS6000, RFS4000, and RFS7000 CLI users, generic examples
are used throughout this guide. These examples are relevant to each switch.
Example
RFSwitch>cluster-cli enable
RFSwitch>
The CLI syntax, parameters and descriptions within this guide can also be used generically
for a RFS6000, RFS4000, and RFS7000 model switch. However, some subtle differences
do exist amongst these baselines. These differences are noted within the specific
commands impacted. When these differences are noted, the options available to each
switch baseline are described in detail.
To Next Page
Loading...
