Motorola RFS Series

Interface Instance
12-29
12.1.17 spanning-tree
 Interface Config Commands
Configures spanning tree parameters
Displays current system information running on the switch.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
spanning-tree [bpdufilter|bpduguard|edgeport|force-version|
guard|link-type|mst|portfast]
spanning-tree bpdufilter [enable|disable]
spanning-tree bpduguard [enable|disable]
spanning-tree [edgeport|portfast]
spanning-tree force-version <1-3>
spanning-tree guard root
spanning-tree link-type [point-to-point|shared]
spanning-tree mst [<1-15|port-cisco]
spanning-tree mst 1 [cost <>|port-priority <>]
spanning-tree mst port-cisco [enable|disable]
Parameters
bpdufilter [disable|enable] Use this command to set a portfast BPDU filter for the
port. Use the
no parameter with this command to revert
the port BPDU filter to default. The spanning tree protocol
sends BPDUs from all ports. Enabling the BPDU filter
ensures PortFastenabled ports do not transmit or receive
BPDUs.