Motorola RFS Series

Wireless Instance
20-37
20.1.18 convert-ap
 Wireless Configuration Commands
Changes the mode of operation of an AP to either sensor or standalone
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
convert-ap <ap-index> [default|sensor|standalone]
convert-ap <ap-index> [default|standalone]
convert-ap <ap-index> sensor {static-ip <IP/Mask>
{<gateway-IP>}}
NOTE: The number of APs supported by convert-ap command differs
for each switch.
• RFS7000 supports <1-256> APs
• RFS6000 supports <1-64> APs
• RFS4000 supports <1-6> APs