Wireless Instance
20-31
20.1.15 client
Wireless Configuration Commands
Use this command to configure a wireless client
This command creates an exclude-list or include list. Creating a list moves the user to a
new mode
config-wireless-client-list.
Refer section config-wireless-client-list Commands on page 20-33 for
(config-wireless-client-list) command summary.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
client [exclude-list|include-list] <list-name>
Parameters
Example
RFSwitch(config-wireless)#client exclude-list JustMe
RFSwitch(config-wireless-client-list)#
exclude-list <list-name> Sets the wireless client exclude list configuration. A MU
NAC check is conducted, except for those in the exclude
list. Devices in the exclude list will not have a NAC check
performed.
include-list <list-name> Defines the wireless client include list configuration. No
MU NAC check is conducted, except for those in the include
list. Devices in the include-list will have NAC checks.
<list-name> Name of the list to be created.
To Next Page
Loading...
