Motorola RFS Series

Motorola RF Switch CLI Reference Guide
5-88
5.1.30 redundancy
 Global Configuration Commands
Configures redundancy group parameters
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
redundancy [auto-revert|auto-revert-period|
critical-resource-ip|dhcp-server|discovery-period|
dynamic-ap-load-balance|enable|group-id|handle-stp|
heartbeat-period|hold-period|interface-ip|manual-revert|
member-ip|mode]
redundancy auto-revert enable
redundancy auto-revert-period <1-1800>
redundancy critical-resource-ip <IP>
redundancy dhcp-server enable
redundancy discovery-period <10-60>
redundancy dynamic-load-balance [enable|per-ap-mu-threshold|
schedule-interval|schedule-start-time|trigger]
redundancy dynamic-ap-load-balance enable
redundancy dynamic-ap-load-balance per-ap-mu-threshold
<1-512>
redundancy dynamic-ap-load-balance schedule-interval <1-336>
redundancy dynamic-ap-load-balance schedule-start-time
<HH:MM> <1-31> <1-12> <2008-2035>
redundancy dynamic-ap-load-balance trigger
[runtime|schedule]
redundancy enable
redundancy group-id <1-65535>
redundancy handle-stp enable
redundancy heartbeat-period <1-255>
redundancy hold-period <10-255>
redundancy interface-ip <IP>
redundancy manual-revert
redundancy member-ip <IP>
redundancy mode [primary|standby]