Common Commands
2-7
2.1.5 service
Common Commands
Service commands are used to manage the switch configuration in all modes. Depending
on the mode, different service commands will display.
• RFS7000
• RFS6000
• RFS4000
Syntax (User Executable Mode)
service [clear|diag|encrypt|kill|locator|save-cli|show|
undefine|wireless]
service [locator|save-cli|undefine]
service clear [command-history|reboot-history|
upgrade-history]
service diag [enable|identify|limit|period|poe
tech-support-period|tech-support-url]
service diag [enable|identify]
service diag poe debug
service diag limit [buffer|fan|filesys|inodes|load|maxFDs|
pkbuffers|procRAM|ram|routecache|temperature]
service diag limit buffer
[128|128k|16k|1k|256|2k|32|32k|4k|512|64|64k|8k]
<0-65535>
service diag limit fan <1-3> low <1000-15000>
service diag limit filesys [etc2|flash|var]
<limit-as-percent>
service diag limit inodes [etc2|flash|var]
<limit-as-percent>
service diag limit load [01|05|15] <load-as-percent>
service diag limit maxFDs <0-32767>
service diag limit pkbuffers <0-65535>
service diag limit procRAM <0.0-100.0>
service diag limit ram <0.0-25.0>
service diag limit routecache <0-65535>
service diag limit temperature <temp-sensor-number>
[critical|high|low] <temperature>
service diag period <100-30000>
service diag tech-support-period <10-10080>
service diag tech-support-url <URL>
service encrypt secret 2 <passphrase> plaintext <plaintext>
service kill connection {<1-64>}
To Next Page
Loading...
