Motorola RFS Series

Global Configuration Commands
5-87
5.1.29 ratelimit
 Global Configuration Commands
Configures rate limit parameters
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
ratelimit [arp|bcast|mcast|ucast] [<0-7>|alerts|critical|
debugging|emergencies|errors|informational|notifications|
warnings]
Parameters
Example
RFSwitch(config)# ratelimit arp log 0
RFSwitch(config)# ratelimit arp log emergencies
ratelimit
[arp|bcast|mcast|ucast]
[<0-7>|alerts|critical|
debugging|emergencies|
errors|informational|
notifications|warnings]
Sets the logging levels for ratelimit feature.
• [arp|bcast|mcast|ucast] – Sets the protocol
• <0-7> – Log severity level
• alerts – immediate action needed
• critical –Critical conditions
• debugging – Debugging messages
• emergencies – System is unusable
• errors – Error conditions
• informational – Informational messages
• notifications – Normal but significant conditions
• warnings – Warning conditions