SOLE Instance
Use the (config-rtls-sole) instance to configure SOLE Location Engine related
parameters.
To navigate to this instance, use the commands
RFSwitch(config)#rtls
RFSwitch(config-rtls)#sole
RFSwitch(config-rtls-sole)#
24.1 SOLE Config Commands
Table 24.1 summarizes config-rtls-sole commands:
Table 24.1 Location Engine Config Command Summary
Command Description Ref.
clrscr Clears the display screen page 24-3
end Ends the current mode and moves to EXEC mode page 24-4
exit Ends current mode and moves to the previous mode page 24-5
help Description of the interactive help system page 24-6
locate Configures location commands page 24-7
no Negates a command or set its defaults page 24-9
redundancy Enables redundancy support across cluster members
for SOLE
page 24-10
To Next Page
Loading...
