Motorola RFS Series

DHCP Class Instance
14-9
14.1.7 option
 DHCP Server Class Config Commands
Specifies a value for DHCP user class options
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
option user-class <class-name>
Parameters
Example
RFSwitch(config-dhcpclass)#option user-class MC800
RFSwitch(config-dhcpclass)#
14.1.7.1 Creating a DHCP User Class
Complete the steps below to create a DHCP user class:
1. Create a DHCP class named
RFS7000DHCPclass. The switch supports a maximum of
32 DHCP classes.
RFSwitch(config)#ip dhcp class RFS7000DHCPclass
RFSwitch(config-dhcpclass)#
2. Create a USER class named MC800. The privilege mode changes to (config-
dhcpclass)
. The switch supports a maximum of 8 user classes per DHCP class.
RFSwitch(config-dhcpclass)#option user-class MC800
RFSwitch(config-dhcpclass)#
3. Create a Pool named WID, using the(config)# mode.
RFSwitch(config)#ip dhcp pool WID
RFSwitch(config-dhcp)#
user-class <class-name>
Creates/modifies DHCP server user class options
• <class-name> – ASCII value of user-class option