Motorola RFS Series

Motorola RF Switch CLI Reference Guide
19-18
Usage Guidelines
Use [no] rate-limit [wired-to-wireless|wireless-to-wired]to remove the
rate limit applied to the group.
[no] rate-limit [wireless-to-wired] sets the rate limit back to unlimited
Example
RFS6000(config-radsrv-group)#rate-limit wired-to-wireless
100
RFS6000(config-radsrv-group)#
RFS6000(config-radsrv-group)#rate-limit wireless-to-wired
1000
RFS6000(config-radsrv-group)#
19.1.7.11 service
 Radius Configuration Commands
Invokes RADIUS service commands (if they have been stopped). This command enables
the RADIUS server. A RADIUS restart is executed only from the
config mode.
Syntax
service show cli
Parameters
None
Example
RFSwitch(config-radsrv-group)#service show cli
Radius user group configuration mode:
+-clrscr [clrscr]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-group
+-WORD [group WORD]
+-guest-group
wireless-to-wired
<100-100000>
Up link direction from wireless client to network
• <100-100000> – Rate in the range of <100-100000> kbps