Motorola RF Switch CLI Reference Guide
12-16
12.1.11 no
Interface Config Commands
Negates a command or sets its defaults
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [crypto|description|duplex|ip|mac|port-channel|
shutdown|spanning-tree|speed|static-channel-group|
storm-control|switchport]
Parameters
The no command negates any command associated with it. Wherever required, use the
same parameters associated with the command getting negated.
Example
RFSwitch(config-if)#no duplex
RFSwitch(config-if)#
SWITCH NOTE: The following commands are not supported
on RFS6000:
• port-channel
• static-channel-group
SWITCH NOTE: The following command is not supported on
RFS7000:
• power
To Next Page
Loading...
