Motorola RF Switch CLI Reference Guide
20-92
Example
RFSwitch(config-wireless)#sensor vlan 268 500
RFSwitch(config-wireless)#
default-config [
gateway-ip|ip-mode|
wips-server-ip]
Invokes the default configuration sent to sensors when
configured.
• gateway-ip <IP> – Configure the gateway IP address for
sensors to <IP>
• ip-mode [dhcp|static <IP/Mask>] – Configures the IP
address of the sensors
• dhcp – Sensors use DHCP to obtain an IP address.
• static <IP/Mask> – Sensors use the specific static IP
address
• <IP/Mask> – Sets the sensor IP address and
network mask
• wips-server-ip [primary|secondary] <IP> – Specifies the
IP addresses of the WIPS server
• primary <IP> – Specifies the primary IP address of the
WIPS server
• secondary <IP> – Specifies the secondary IP address
of the WIPS server
ping-interval <2-60> Sets the ping interval (in seconds) between successive
pings to sensors on the network.
vlan <1-4094> Configures VLANs where sensors are discovered.
• <1-4094> – Vlan IDs
To Next Page
Loading...
