Motorola RF Switch CLI Reference Guide
5-90
Example
RFSwitch(config)#redundancy discovery-period 20
RFSwitch(config)#
RFSwitch(config)#redundancy handle-stp enable
RFSwitch(config)#
RFSwitch(config)#redundancy heartbeat-period 20
RFSwitch(config)#
RFSwitch(config)#redundancy hold-period 25
RFSwitch(config)#
RFSwitch(config)#redundancy mode primary
RFSwitch(config)#
interface-ip <IP> Sets the redundancy interface IP address
manual-revert Reverts standby to non-active mode
member-ip <IP> Adds a member with the IP <IP> to this redundancy group
mode [primary|standby] Sets the mode to either primary or standby
To Next Page
Loading...
