EasyManua.ls Logo

Motorola RFS Series

Motorola RFS Series
1054 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Motorola RF Switch CLI Reference Guide
15-6
deny icmp [<source-IP/
Mask>|any|host <IP>]
[<dest-IP/Mask>|any|host
<IP>] {<ICMP-type>
{<ICMP-code>}} {log}
{rule-precedence <1-
5000>}
Use with the deny command to reject ICMP packets
deny – Rejects ICMP packets
icmp – Specifies ICMP as the protocol
[<source-ip/mask>|any|host <IP>] – The source <source-
IP> is the source IP address of the network or host (in
dotted decimal format). The <mask> is the network
mask. For example, 10.1.1.10/24 indicates the first 24
bits of the source IP is used for matching
any – any is an abbreviation for a source IP of 0.0.0.0 and
source-mask bits equal to 0
host – host is an abbreviation for exact source (A.B.C.D)
and source-mask bits equal to 32
[<dest-IP/Mask>|any|host <IP>] – Defines the
destination host IP address or destination network
address
<ICMP-type> {<ICMP-code>} – Sets the ICMP type value
<ICMP-type> from 0 to 255, and is valid only for ICMP.
The ICMP code value <ICMP-code> is from 0 to 255, and
is valid only for protocol type icmp
log – Generates log messages when the packet coming
from the interface matches the ACL entry. Log messages
are generated only for router ACLs
rule-precedence <1-5000> – Optional. Defines an integer
value between 1-5000. This value sets the rule
precedence in the ACL

Table of Contents

Other manuals for Motorola RFS Series

Related product manuals