Motorola RFS Series

Extended ACL Instance
15-21
15.1.7 no
 Extended ACL Config Commands
Negates a command or sets its defaults
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [deny|mark|permit]
Negates all the syntax combinations used in the deny, mark and permit designations to
configure the Extended ACL
Parameters
Usage Guidelines
Removes an access list control entry. Provide the rule-precedence value when using the
no command.
Example
RFSwitch(config-ext-nacl)#no mark 8021p 5 tcp 192.168.2.0/24
any rule-precedence 10
RFSwitch(config-ext-nacl)#
RFSwitch(config-ext-nacl)#no permit ip any any rule-
precedence 10
RFSwitch(config-ext-nacl)#
RFSwitch(config-ext-nacl)#no deny icmp any any rule-
precedence 10
RFSwitch(config-ext-nacl)#
deny Specifies packets to reject
mark Specifies packets to mark
permit Specifies packets to forward