Motorola RFS Series

Motorola RF Switch CLI Reference Guide
20-12
20.1.5 ap
 Wireless Configuration Commands
Defines the name, location and other parameters of access ports
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
ap [<1-256>|<LIST>|<MAC-ADDRESS>|all-aap|default-aap] [ABG
Scan|aap-log-storage|aap-admin-passwd| ||adoption-policy|
|aap-ipfilter-list|aap-lan1-ipf-rules |aap-lan1-
trunking|aap-syslog-srvr|country-code|lan-
acl|location|name|radio-config|secure-mode||secure-mode-
staging]
ap [all-aap|default-aap]aap-lan1-trunking [disable|enable]
ap <1-256> aap-admin-passwd <LINE>
ap <1-256> aap-log-storage enable
ap <1-256> aap-syslog-srvr enable level <0-7> ipaddr
ap <1-256> adoption-policy [allow|deny]
ap <1-256> country-code <country-code>
ap <1-256> leds (enable)
ap <1-256> location <location>
ap <1-256> name <name>
ap <1-256> secure-mode [enable|secret [0 <secret>|
2 <secret>|<secret>]
ap <1-256> secure-mode-staging enable
ap <1-256> aap-ipfilter-list <AAP-IPFiltername>
ap <1-256> aap-lan1-ipf-rules [in|out]
{<1-20>|<AAP_IP_RULE>}
ap <1-256> aap-lan1-trunking [disable|enable mgmt-vlan-id
<1-4094> native-vlan-id <1-4094> native-tagging
[tagged|untagged]]
ap <LIST> adoption-policy [allow|deny]
ap <LIST> aap-log-storage enable