Wireless Instance
20-63
20.1.38 no
Wireless Configuration Commands
Negates a command or sets its defaults. All the parameters mentioned in the syntax can
be negated using the
no command.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [aap|admission-control|adoption-pref-id|
adopt-unconf-radio|ap|ap-containment|ap-detection|ap-image|
ap-ip|ap-standby-attempts-threshold|ap-timeout|ap-udp-port|
auto-select-channel|broadcast-tx-speed|client|
cluster-master-support|country-code|debug|
dhcp-one-portal-forward|dhcp-sniff-state|
dot11-shared-key-auth|fix-broadcast-dhcp-rsp|hotspot|ids|
mac-auth-local|manual-wlan-mapping|mobile-unit|mobility|
multicast-packet-limit|multicast-throttle-watermarks|nas-id|
nas-port-id|proxy-arp|qos-mapping|radio|rate-limit|
secure-wispe-default-secret|self-heal|
sensor|service|show|smart-rf|
smart-scan-channels|wips|wlan|wlan-bw-allocation]
Parameters
Refer to the individual commands for the parameters negated using the no command.
Example
RFSwitch(config-wireless)#no mobility enable
RFSwitch(config-wireless)#
RFS6000(config-wireless)#no ap-image ?
ap100 ap image for ap100
ap300-ids-sensor IDS Sensor firmware for ap300
ap300-wisp WISP image for ap300
ap300-wispe WISPe image for ap300
ap4131 ap image for ap4131
ap5131 Adaptive AP image for ap5131
ap650-wispe ap image for ap650
ap7131 Adaptive AP image for ap7131
revert-ap4131 ap image for revert-ap4131
RFS6000(config-wireless)#
To Next Page
Loading...
