Motorola RF Switch CLI Reference Guide
20-100
wireless [ap-history|
clear-ap-log|custom-cli|
dot11i|dump-core|
enhanced-beacon-table|
enhanced-probe-table|
free-packet-watermark|
idle-radio-send-
multicast|
legacy-load-
balance|map-radios|
radio-misc-cfg|
rate-scale|
request-ap-log|
save-ap-log|
snmp-trap-throttle|
sync-radio-entries|
vlan-cache]
Configures wireless parameters.
• ap-history [clear|enable] – Configures access port history
• clear – Clears all history of all APs
• enable – Enables tracking of AP history
• custom-cli [sh-wi-mobile-unit|sh-wi-radio] – Customize
the output of some summary cli commands in wireless
• sh-wi-mobile-unit [ap-locn|ap-name|channel|
dot11-type|ip|last-heard|mac|radio-bss|
radio-desc|radio-id|ssid|state|vlan|wlan-desc|
wlan-id|username] – Customize the output of the
"
show wireless mobile-unit” command
• ap-locn – The location of the AP where the
mobile-unit is associated
• ap-name – The name of the AP where the
mobile-unit is associated
• channel – The channel of the radio where the
mobile-unit is associated
• dot11-type – The dot11 radio type of the mobile-
unit.
• ip – The IP address of the mobile-unit
• last-heard – The time when a packet was last
received from the mobile-unit.
• mac – MAC address of mobile-unit
• radio-bss – The BSSID of the radio where the
mobile-unit is associated
• radio-desc – Description of radio where the mobile-
unit is associated
• radio-id – The radio index to which the mobile-unit
is associated
• ssid – The SSID of the mobile-units wlan
• state – The current state of the mobile-unit
To Next Page
Loading...
Need help?
General
