Motorola RFS Series

Wireless Instance
20-141
radius [accounting|
authentication-protocol|
dscp|
dynamic-authorization|
dynamic-vlan-
assignment|
mac-auth-format|
mobile-unit|
reauth|server]
Configures RADIUS parameters for the select WLAN.
• accounting [mode|server|timeout] – Sets RADIUS
accounting parameters.
• mode [start-stop|stop-only|start-interim-stop] – Sets
the Accounting Mode
• start-stop – Sends accounting start-stop
• stop-only – Sends accounting stop-only
• start-interim-stop interval <60-3600> – Sets the
time interval between successive accounting
updates to a value in the range 60 to 3600 secs
• server [primary|secondary] [<IP> {acct-port <port>}|
radius-key [0 <key>|2 <key>|<key>]] – Sets the primary
or secondary RADIUS server for the selected WLAN
• primary – Sets primary RADIUS server information.
• secondary – Sets secondary RADIUS server
information
• <IP> – Sets the IP address of the RADIUS server
• acct-port <port> – Sets the optional radius server
accounting port. Default is 1813
• radius-key [0 <key>|2 <key>|<key>] – Sets the
radius-key for the RADIUS server
• 0 <key> – The key is sent unencrypted
• 2 <key> – The key is sent encrypted with the
password-encryption secret
• <key> – The shared key
• timeout <1-300> – Sets the time the wireless switch
waits for a response from the RADIUS server before
retrying accounting
• <1-300> – The time duration in seconds. The
default value is 5sec.
• retransmit <1-100> – Number of retries before the
wireless switch will give up Accounting.
• <1-100> – Retry count. The default value is 3.