Motorola RFS Series

Motorola RF Switch CLI Reference Guide
20-152
wips events 80211-
replay-check-failure| ad-
hoc-advertising-
authorized-ssid | ad-hoc-
network-violation-
authorized-device |ad-hoc-
network-violation-
unauthorized-device
|aggressive-scanning |all|
ap-default-configuration |
ap-ssid-broadcast-in-
beacon| crackable-wep-iv-
key-used | decryption-
failures |
dos-association-or-
authentication-flood |
dos-broadcast-
deauthentication | dos-
eapol-start-storm | dos-
unicast-deauthentication-
or-disassociation |eap-
flood | eap-nak-flood |
failures-reported-by-
authentication-servers |
fake-ap-flood |frames-
from-unassociated-
stations | frames-with-
bad-essids |fuzzing-all-
zero-mac-address-
observed |fuzzing-invalid-
frame-type-detected |
fuzzing-invalid-
management-
frame|fuzzing-invalid-
sequence-number]
Configures parameters related to the detection of
anomalous frames on the RF network. The parameters are:
• 80211-replay-check-failure – Detects 802.11 replay
failure
• ad-hoc-advertising-authorized-ssid – Detects ad-hoc
advertising authorized ssid
• ad-hoc-network-violation-authorized-device – Enables
ad-hoc network violation authorized device
• ad-hoc-network-violation-unauthorized-device –
Enables ad-hoc network violation unauthorized device
• aggressive-scanning – Detects aggressive scanning
• all – Enables all types of events
• ap-default-configuration – Detects ap default
configuration
• ap-ssid-broadcast-in-beacon – Detects ap ssid
broadcast in beacon
• crackable-wep-iv-key-used – Uses crackable wep iv key
• decryption-failures – Detects decryption failures
• dos-association-or-authentication-flood – Detects dos
association or authentication flood
• dos-broadcast-deauthentication – Detects dos
broadcast - deauthentication
• dos-eapol-start-storm – Detects dos eapol-start storm
• dos-unicast-deauthentication-or-disassociation –
Detects dos unicast deauthentication or disassociation
• eap-flood – Detects eap flood
• eap-nak-flood – Detects eap-nak-flood
• failures-reported-by-authentication-servers – Detects
failures reported by authentication servers