Motorola RF Switch CLI Reference Guide
23-8
23.1.6 no
RFID Instance
Supported in the following platforms: Negates a RTLS command or set its defaults
• RFS7000
• RFS6000
• RFS4000
Syntax
no [activate|reader|service]
Parameters
Usage Guidelines
Use [no] command to undo the configurations on the parameters mentioned in the table.
Refer to the parameters, within this chapter, for complete syntax.
Example
RFSwitch(config-rtls-rfid)#no activate
RFSwitch(config-rtls-rfid)#
activate
Deactivates/disables RTLS adapter
reader
Disables RFID reader configuration commands
service
Disables service commands
To Next Page
Loading...
