Motorola RF Switch CLI Reference Guide
25-8
Parameters
Example
RFSwitch(config-wireless-smart-rf)#hold-time 400
RFSwitch(config-wireless-smart-rf)#
25.1.9 no
Smart RF Instance
Disables the Smart RF configurations
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
no [assignable-power-range|auto-assign|extensive-scan|
hold-time|number-of-rescuers|radio|recover|
retry-threshold|scan-dwell-time|schedule-calibrate|
select-channels|service|smart-rf-module|verbose]
no assignable-power-range [<4-20> <4-20>]
no auto-assign [all|channel|detector|power|rescuer]
no extensive-scan enable
no number-of-rescuers
no radio [<1-4096>|MAC-ADDRESS|RADIO|all-11a|all-11b|
all-11bg]
no recover [coverage-hole|interference|neighbor] enable
no retry-threshold [<0.0-15.0>]
no scan-dwell-time [<1-10>]
hold-time <30-65535> The number of seconds to disable interface avoidance after
a detection. This prevents the radio from changing channels
continuously. Set the values in seconds from 30-65535.
To Next Page
Loading...
