Configuring the Internal Baseband Source
R&S
®
SMBV100B
236User Manual 1178.4460.02 ─ 03
Delay Start.................................................................................................................. 237
Delay Step...................................................................................................................237
Input Waveform File.................................................................................................... 237
Apply Assistant Settings..............................................................................................237
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe on page 769
Carrier Start/Start
Defines the start/stop index of the carrier range to which the assistant settings are
intended to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt on page 770
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP on page 770
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 770
Gain Step
Sets the step width that is used to increment the gain.
The resulting carrier gain in the carrier table equals:
Gain =
"Gain Start" + n*"Gain Step".
Where n is a value between 0 and ("Carrier Stop" - "Carrier Start").
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 770
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 771
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
Phase =
"Phase Start" + n*"Phase Step"
Where n is a value between 0 and ("Carrier Stop" - "Carrier Start").
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 770
Generating Multi-Carrier Signals
To Next Page
Loading...
