Configuring the RF Signal
R&S
®
SMBV100B
290User Manual 1178.4460.02 ─ 03
In the "RF Frequency" dialog, you can configure:
● RF frequency, incl. an offset or multiplication factor of a downstream instrument
● The step size for varying the frequency with the rotary knob.
The remote commands required to define the settings are described in Chap-
ter 12.16.6, "SOURce:FREQuency Subsystem", on page 820.
Settings
Frequency................................................................................................................... 290
Offset...........................................................................................................................291
Multiplier......................................................................................................................291
User Variation..............................................................................................................291
└ Variation Active............................................................................................. 291
└ Variation Step................................................................................................291
Frequency
Sets the RF frequency.
This frequency is output at the RF connector. It does not consider an Offset or multipli-
cation factor (Multiplier).
See "RF frequency and level display with a downstream instrument" on page 288.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
– Annotation Frequency
– Annotation Amplitude
RF Frequency Settings
To Next Page
Loading...
