Rohde & Schwarz SMBV100B - Page 766

Remote Control Commands
R&S
®
SMBV100B
764User Manual 1178.4460.02 ─ 03
Parameters:
<Spacing> float
Range: 0.0 to depends on the installed options, e.g.
120E6
Increment: 0.01
*RST: 0
Default unit: Hz
Example: See Example "Generating a multi carrier signal" on page 744
Manual operation: See "Carrier Spacing" on page 228
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SAMPles?
Queries the resulting file size.
Return values:
<Samples> integer
Range: 0 to INT_MAX
*RST: 0
Default unit: samples
Example:
SOURce1:BB:ARBitrary:MCARrier:SAMPles?
Queries the file size of the currently calculated multi-carrier
waveform.
Usage: Query only
Manual operation: See "File Size" on page 232
[:SOURce<hw>]:BB:ARBitrary:MCARrier:TIME <Time>
Sets the user-defined signal period.
Parameters:
<Time> float
Range: 0 to 1E9
Increment: 1E-9
*RST: 0
Default unit: s
Example:
SOURce1:BB:ARBitrary:MCARrier:MODE USER
Selects signal period mode user.
SOURce1:BB:ARBitrary:MCARrier:TIME 10
Sets a signal period of 10 seconds
Manual operation: See "Signal Period" on page 230
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CFACtor:MODE <Mode>
Sets the mode for optimizing the crest factor by calculating the carrier phases.
SOURce Subsystem