Rohde & Schwarz SMBV100B - Page 786

Remote Control Commands
R&S
®
SMBV100B
784User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe............................................................. 786
[:SOURce<hw>]:BB:MCCW:CARRier:PHASe................................................................... 787
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe............................................................787
[:SOURce<hw>]:BB:MCCW:CARRier:POWer................................................................... 788
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer............................................................788
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt]............................................... 789
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt]............................................... 789
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP..................................................789
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP..................................................789
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt.............................................................790
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP.............................................................790
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe.............................................................790
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute.........................................................790
[:SOURce<hw>]:BB:MCCW:PRESet
Sets all multi carrier signal parameters to their default values.
Example:
See "Programming Examples" on page 779
Usage: Event
Manual operation: See "Set to Default" on page 243
[:SOURce<hw>]:BB:MCCW:STATe <State>
Enables/disables the multi carrier CW signal.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See "Programming Examples" on page 779
Manual operation: See "State" on page 242
[:SOURce<hw>]:BB:MCCW:CARRier:COUNt <Count>
Sets the number of carriers in the multi carrier CW signal.
Parameters:
<Count> integer
Range: 1 to 160001
*RST: 64
Example: see "Programming Examples" on page 779
Manual operation: See "Number of Carriers" on page 243
[:SOURce<hw>]:BB:MCCW:CARRier:SPACing <Spacing>
Sets the carrier spacing.
SOURce Subsystem