Rohde & Schwarz SMBV100B - Page 829

Remote Control Commands
R&S
®
SMBV100B
827User Manual 1178.4460.02 ─ 03
[:SOURce<hw>]:FREQuency:CENTer <Center>
Sets the center frequency of the sweep.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Parameters:
<Center> float
Range: 300 kHz to RFmax
Increment: 0.01 Hz
*RST: 300E6
Default unit: Hz
Example: See Example "Setup an RF frequency or power sweep"
on page 882
Manual operation: See " Center Frequency " on page 332
[:SOURce<hw>]:FREQuency:SPAN
<Span>
Sets the sapn of the frequency sweep range.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Parameters:
<Span> float
Full freqeuncy range
Increment: 0.01
*RST: 400E6
Example: See Example "Setup an RF frequency or power sweep"
on page 882
Manual operation: See "Span" on page 332
[:SOURce<hw>]:FREQuency:STARt <Start>
Sets the start frequency for the RF sweep.
See Chapter 6.10.2.1, "Correlating Parameters in Sweep Mode", on page 320.
Parameters:
<Start> float
Range: 300kHz to RFmax
Increment: 0.01Hz
*RST: 100 MHz
Example: See Example "Setup an RF frequency or power sweep"
on page 882
Manual operation: See " Start Frequency/Stop Frequency " on page 332
SOURce Subsystem