Remote Control Commands
R&S
®
SMBV100B
842User Manual 1178.4460.02 ─ 03
Parameters:
<Start> float
Range: 0.1 Hz to 1 MHz
Increment: 0.1
*RST: 1 KHz
<Stop> float
Range: 0.1 Hz to 1 MHz
Increment: 0.1 Hz
*RST: 100 KHz
Example: See Example "Setup an LF sweep" on page 837.
Manual operation: See " Start Frequency/Stop Frequency " on page 332
[:SOURce]:LFOutput<ch>[:STATe]
<State>
Activates LF signal output.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the LF generator" on page 838.
Manual operation: See "State" on page 371
[:SOURce]:LFOutput<ch>:INTernal:VOLTage <Voltage>
Sets the output voltage for the LF generators.
The sum of both values must not exceed the overall output voltage, set with command
[:SOURce]:LFOutput:VOLTage.
Suffix:
<ch>
.
[1]|2
LF1 and LF2
Parameters:
<Voltage> float
Range: 0 to 4
Increment: 0.001
*RST: 1
Example: See Example "Configuring the LF generator" on page 838.
Manual operation: See "Output Voltage" on page 371
[:SOURce]:LFOutput:OFFSet <Offset>
Sets a DC offset at the LF Output.
SOURce Subsystem
To Next Page
Loading...
