Remote Control Commands
R&S
®
SMBV100B
879User Manual 1178.4460.02 ─ 03
Parameters:
<Frequency> float
Range: 1E6 to 100E6
Increment: 0.1
*RST: n.a. (factory preset: 1E7)
Default unit: Hz
Example: See Example "Configuring the reference oscillator" on page 877.
Options: R&S SMBVB-K704
Manual operation: See "Variable Reference Frequency" on page 303
[:SOURce]:ROSCillator:EXTernal:SBANdwidth
<SBandwidth>
Selects the synchronization bandwidth for the external reference signal.
For more information, see data sheet.
Parameters:
<SBandwidth> WIDE | NARRow
NARRow
The synchronization bandwidth is a few Hz.
Suitable for external reference sources with phase noise worse
than the R&S SMBV100B.
WIDE
Uses the widest possible synchronization bandwidth.
For more information, see data sheet.
*RST: n.a. (factory preset)
Example: See Example "Configuring the reference oscillator" on page 877.
Manual operation: See "Synchronization Bandwidth" on page 303
[:SOURce]:ROSCillator:EXTernal:MLRange?
Queries the minimum locking range for the selected external reference frequency.
Return values:
<MinLockRange> string
Example:
SOUR:ROSC:EXT:MLR?
Usage: Query only
Manual operation: See "Minimum Locking Range" on page 303
[:SOURce]:ROSCillator:EXTernal:NSBandwidth?
Queries the nominal synchronization bandwidth for the selected external reference fre-
quency and synchronization bandwidth.
SOURce Subsystem
To Next Page
Loading...
