Rohde & Schwarz SMBV100B - Page 882

Remote Control Commands
R&S
®
SMBV100B
880User Manual 1178.4460.02 ─ 03
Return values:
<NomBandwidth> string
Example:
SOUR:ROSC:EXT:NSB?
Usage: Query only
Manual operation: See "Nominal Synchronization Bandwidth" on page 303
[:SOURce]:ROSCillator:OUTPut:FREQuency:MODE <OutpFreqMode>
Selects the mode for the output reference frequency.
Parameters:
<OutpFreqMode> DER10M | OFF | LOOPthrough
OFF
Disables the output.
DER10M
Sets the output reference frequency to 10 MHz.
The reference frequency is derived from the internal reference
frequency.
LOOPthrough
This option is unavailable for
ROSCillator:EXTernal:FREQuency 1GHZ. Forwards the
input reference frequency to the reference frequency output.
*RST:
n.a. (factory preset: DER10M)
Example: See Example "Configuring the reference oscillator" on page 877.
Manual operation: See "Reference Output/1GHz Reference Output" on page 304
[:SOURce]:ROSCillator:OUTPut:ALTernate:FREQuency:MODE <OutpFreqMode>
Sets the output reference frequency.
Parameters:
<OutpFreqMode> LOOPthrough | DER1G | OFF
OFF
Disables the output.
DER1G
Sets the output reference frequency to 1 GHz.
The reference frequency is derived from the internal reference
frequency.
LOOPthrough
If [:SOURce]:ROSCillator:EXTernal:FREQuency1GHZ,
forwards the input reference frequency to the reference fre-
quency output.
*RST:
n.a. (factory preset: OFF)
Example: See Example "Configuring the reference oscillator" on page 877.
SOURce Subsystem