Rohde & Schwarz SMBV100B - Page 932

Maintenance
R&S
®
SMBV100B
930User Manual 1178.4460.02 ─ 03
To set the date and time
1. Press the [Setup] key.
2. Select "Security > Protection".
3. Enable the "Protection Level 1".
The default password is 123456.
4. Select "Setup > Maintenance > Date / Time".
5. Adjust the settings.
6. Close the dialogs.
The instrument adopts the new date and time.
Settings:
Date.............................................................................................................................930
Time............................................................................................................................ 930
Timezone.....................................................................................................................930
NTP Address...............................................................................................................930
Use Time from NTP Server.........................................................................................931
Date
Displays the date set in the operating system in the format [dd.mm.yyyy].
Remote command:
:SYSTem:DATE on page 909
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Use Time from NTP Server.
Remote command:
:SYSTem:TIME on page 910
Timezone
Selects the timezone.
You can select the timezone according to the major cities on the respective continents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 911
:SYSTem:TIME:ZONE:CATalog? on page 911
NTP Address
Sets the IP address or host name of the NTP server.
NTP is a network time protocol used for synchronizing all participating devices in a
data network.
You can select a high-precision time server to reduce the impact of varying network
delays.
Performing Maintenance Tasks