19．EtherNet/IP COMMUNICATION
This instance supports the following services.
(a) When Ins ID is 0
Reads the values of all the attributes.
Reads the value of the specified attribute.
Reads the values of all the attributes.
Calls the Reset service of the specified class/object.
Reads the value of the specified attribute.
Writes a value to the specified attribute.
If the value of the reset type is set to "0" in the Reset service, parameter settings,
etc. are still written to the EEP-ROM. Note that the number of write times to
the EEP-ROM is limited to 100,000. If the total number of write times exceeds
100,000, the driver may malfunction when the EEP-ROM reaches the end of its
useful life.
The following table lists the reset types that can be used with the Reset service.
Emulate as closely as possible cycling power on the item the Identity Object represents. This value is the default if this
parameter is omitted. The network card, driver and MR-D30 functional safety unit do not restore the default values of each
parameter.
Return as closely as possible to the factory default configuration, then emulate cycling power as closely as possible. The
network card restores the default values of communication setting, such as an IP address. The parameters of the driver
and MR-D30 functional safety unit are reset to the factory setting.
The following set values of the driver can be rewritten with the factory setting.
Basic setting parameters ([Pr. PA_ _ ])
Gain/filter setting parameters ([Pr. PB_ _ ])
Extension setting parameters ([Pr. PC_ _ ]) (except [Pr. PC11] and [Pr. PC12])
I/O setting parameters ([Pr. PD_ _ ])
Extension setting 2 parameters ([Pr. PE_ _ ])
Extension setting 3 parameters ([Pr. PF_ _ ])
Linear servo motor/DD motor setting parameters ([Pr. PL_ _ ])
Positioning control parameters ([Pr. PT_ _])
Network setting parameters ([Pr. PN_ _])
To Next Page
Loading...
Need help?
General
