EasyManua.ls Logo

SMC Networks LECSN-T Series - 11.5 Selection example of wires

SMC Networks LECSN-T Series
1046 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11. OPTIONS AND PERIPHERAL EQUIPMENT
11 - 18
11.5 Selection example of wires
POINT
To comply with the UL/CSA standard, use the wires shown in appendix 4 for
wiring. To comply with other standards, use a wire that is complied with each
standard.
Selection conditions of wire size is as follows.
Construction condition: One wire is constructed in the air.
Wire length: 30 m or less
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
5) Pow er regenerative converter lead
Pow er regenerative
converter
N-
3) Regenerative option lead
Regenerative option
2) Control circuit pow er supply lead
C
P+
L1
L2
L3
L11
L21
1) Main circuit power supply lead
Pow er supply
Servo amplifier
U
V
W
M
4) Servo motor pow er supply lead
(1) Example of selecting the wire sizes
Use the 600 V Grade heat-resistant polyvinyl chloride insulated wire (HIV wire) for wiring. The
following shows the wire size selection example.
Table 11.1 Wire size selection example (HIV wire)
Driver
Wire [mm
2
]
L1
L2
L3
(Note 1)
L11
L21
(Note 2) U
V
W
P
C
(Note 3) B1
B2
10m or less
Extension
cable
10m or less
Extension
cable
LECSN-T5
LECSN-T7
2(AWG14)
1.25(AWG16)
0.75(AWG18)
1.25(AWG16)
2(AWG14)
0.5(AWG20)
1.25(AWG16)
LECSN-T8
LECSN2-T9
Note1. Use 2 mm
2
(AWG14) to comply with IEC/EN/UL/CSA standards.
Note2. Use 2 mm
2
(AWG14) to comply with IEC/EN/UL/CSA standards.
Note3. Use 1.25 mm
2
(AWG16) to comply with IEC/EN/UL/CSA standards.
Driver

Table of Contents

Related product manuals